G-Code
From CNC.xyz Wiki
Header text | Header text |
---|---|
G0 | Coordinated Straight Motion Rapid Rate |
G1 | Coordinated Straight Motion Feed Rate |
G2 G3 | Coordinated Helical Motion Feed Rate |
G4 | Dwell |
G5.1 | Quadratic B-Spline |
G5.2 G5.3 | NURBs Block |
G7 | Diameter Mode (lathe) |
G8 | Radius Mode (lathe) |
G10 L1 | Set Tool Table Entry |
G10 L10 | Set Tool Table, Calculated, Workpiece |
G10 L11 | Set Tool Table, Calculated, Fixture |
G10 L2 | Coordinate System Origin Setting |
G10 L20 | Coordinate System Origin Setting Calculated |
G17 - G19.1 | Plane Select |
G20 G21 | Units of Measure |
G28 - G28.1 | Go to Predefined Position |
G30 - G30.1 | Go to Predefined Position |
G33 | Spindle Synchronized Motion |
G33.1 | Rigid Tapping |
G38.2 - G38.5 | Probing |
G40 | Cancel Cutter Compensation |
G41 G42 | Cutter Compensation |
G41.1 G42.1 | Dynamic Cutter Compensation |
G43 | Use Tool Length Offset from Tool Table |
G43.1 | Dynamic Tool Length Offset |
G49 | Cancel Tool Length Offset |
G53 | Motion in Machine Coordinate System |
G54 - G59 | Select Coordinate System (1 - 6) |
G59.1 - G59.3 | Select Coordinate System (7 - 9) |
G61 G61.1 | Path Control Mode |
G64 | Path Control Mode with Optional Tolerance |
G73 | Drilling Cycle with Chip Breaking |
G76 | Multi-pass Threading Cycle (Lathe) |
G80 | Cancel Motion Modes |
G81 | Drilling Cycle |
G82 | Drilling Cycle with Dwell |
G83 | Drilling Cycle with Peck |
G85 | Boring Cycle, No Dwell, Feed Out |
G86 | Boring Cycle, Stop, Rapid Out |
G89 | Boring Cycle, Dwell, Feed Out |
G90 G91 | Distance Mode |
G90.1 G91.1 | Arc Distance Mode |
G92 | Coordinate System Offset |
G92.1 G92.2 | Cancel Coordinate System Offsets |
G92.3 | Restore Axis Offsets |
G93 G94 G95 | Feed Modes |
G96 | Constant Surface Speed |
G97 | RPM Mode |
G98 G99 | Canned Cycle Z Retract Mode |