Difference between revisions of "Modular Breakout Board"
From CNC.xyz Wiki
| Line 16: | Line 16: | ||
{{Clear}} | {{Clear}} | ||
| + | |||
| + | ==Features== | ||
| + | *Optional connections to Parallel Port (DB-25) or IDC 26 ribbon cable. | ||
| + | *Optional on board 5 volt voltage regulator or USB power connection. | ||
| + | *Pins 11, 12, 13, 15 for Limits and E-Stop connections. Pulled down with 10k resistor. | ||
| + | *Header connections for [[Unipolar Controller]]. | ||
| + | *Selectable "Enable" from DB-25 port, or constant on 5 volt connection. | ||
Revision as of 06:01, January 30, 2014
 Modular Breakout Board | |
| Status | In Development |
|---|---|
| Manufacterer | A Quick CNC |
| Version | 1.0.0 |
| Designer | AJ Quick |
| License | CC BY-SA 3.0 |
Features
- Optional connections to Parallel Port (DB-25) or IDC 26 ribbon cable.
- Optional on board 5 volt voltage regulator or USB power connection.
- Pins 11, 12, 13, 15 for Limits and E-Stop connections. Pulled down with 10k resistor.
- Header connections for Unipolar Controller.
- Selectable "Enable" from DB-25 port, or constant on 5 volt connection.