Difference between revisions of "Unipolar Motor Driver"
From CNC.xyz Wiki
(Created page with "{{Infobox |title = Unipolar Motor Driver |image = |caption = |label2 = Status |data2 = In Development |label3 = Manufacterer |data3 = A Quick CNC |label4 = Versi...") |
|||
(2 intermediate revisions by the same user not shown) | |||
Line 16: | Line 16: | ||
{{Clear}} | {{Clear}} | ||
+ | |||
+ | ==Features== | ||
+ | *Accepts 5, 6 or 8 wire unipolar stepper motors (4 wire type not compatible) | ||
+ | *40 volt DC maximum input voltage, 24 volt DC recommended, 12 volt DC minimum. | ||
+ | *3.0 amps maximum current per phase, 0.5 amp minimum. (Fully adjustable) | ||
+ | *1/1, 1/2, 1/4, 1/8, & 1/16 microstepping. | ||
+ | *Patent pending circuit protection built in to protect against short circuits. | ||
+ | *Buffered and cleaned step and direction signals. | ||
+ | *Automatic switch to synchronous mode after 10 seconds of inactivity (controlled by switch). | ||
+ | *Automatic power reduction after 10 seconds of inactivity (controlled by switch) | ||
+ | *Indicator LED to notify when device is ready / working. | ||
+ | *Enable / disable axis from remote / software. | ||
+ | *[[Modular Motor Driver Connector]] to plug into common breakout boards including [[Modular Breakout Board]] and [[Grbl Breakout Board]]. |
Latest revision as of 00:42, December 16, 2015
Status | In Development |
---|---|
Manufacterer | A Quick CNC |
Version | 1.0.0 |
Designer | AJ Quick |
License | CC BY-SA 3.0 |
Features
- Accepts 5, 6 or 8 wire unipolar stepper motors (4 wire type not compatible)
- 40 volt DC maximum input voltage, 24 volt DC recommended, 12 volt DC minimum.
- 3.0 amps maximum current per phase, 0.5 amp minimum. (Fully adjustable)
- 1/1, 1/2, 1/4, 1/8, & 1/16 microstepping.
- Patent pending circuit protection built in to protect against short circuits.
- Buffered and cleaned step and direction signals.
- Automatic switch to synchronous mode after 10 seconds of inactivity (controlled by switch).
- Automatic power reduction after 10 seconds of inactivity (controlled by switch)
- Indicator LED to notify when device is ready / working.
- Enable / disable axis from remote / software.
- Modular Motor Driver Connector to plug into common breakout boards including Modular Breakout Board and Grbl Breakout Board.