Difference between revisions of "G-Code"
From CNC.xyz Wiki
Line 32: | Line 32: | ||
|- | |- | ||
| [[G33]] || Lathe Thread Cycle | | [[G33]] || Lathe Thread Cycle | ||
− | |||
− | |||
|- | |- | ||
| [[G40]] || Cancel Cutter Compensation | | [[G40]] || Cancel Cutter Compensation | ||
Line 88: | Line 86: | ||
|- | |- | ||
| [[G91]] || Incremental Distance Mode | | [[G91]] || Incremental Distance Mode | ||
− | |||
− | |||
|- | |- | ||
| [[G92]] || Coordinate System Offset | | [[G92]] || Coordinate System Offset |
Revision as of 20:39, January 30, 2014
Header text | Header text |
---|---|
G0 | Rapid Positioning |
G1 | Linear Interpolation |
G2 | Circular Interpolation, Clockwise |
G3 | Circular Interpolation, Counterclockwise |
G4 | Dwell |
G10 | Coordinate System Origin Setting |
G17 | XY Plane Selection |
G18 | XZ Plane Selection |
G19 | YZ Plane Selection |
G20 | Unit Selection: Inch |
G21 | Unit Selection: MM |
G27 | Verify Home |
G28 | Home Return (Soft Home) |
G30 | Home |
G33 | Lathe Thread Cycle |
G40 | Cancel Cutter Compensation |
G41 | Cutter Compensation Left |
G42 | Cutter Compensation Right |
G43 | Tool Length Offset |
G49 | Cancel Tool Length Offset |
G53 | Motion in Machine Coordinate System |
G54 | Select Coordinate System 1 |
G55 | Select Coordinate System 2 |
G56 | Select Coordinate System 3 |
G57 | Select Coordinate System 4 |
G58 | Select Coordinate System 5 |
G59 | Select Coordinate System 6 |
G59.1 | Select Coordinate System 7 |
G59.2 | Select Coordinate System 8 |
G59.3 | Select Coordinate System 9 |
G65 | Subroutine |
G80 | Cancel Motion Modes |
G81 | Drilling Cycle |
G82 | Drilling Cycle with Dwell |
G83 | Drilling Cycle with Peck |
G85 | Boring Cycle, No Dwell, Feed Out |
G86 | Boring Cycle, Stop, Rapid Out |
G87 | Back Boring Cycle |
G88 | Boring Cycle, Stop, Manual Out |
G89 | Boring Cycle, Dwell, Feed Out |
G90 | Absolute Distance Mode |
G91 | Incremental Distance Mode |
G92 | Coordinate System Offset |
G92.2 | Cancel Coordinate System Offsets |
G92.3 | Restore Axis Offsets |
G93 | Inverse Time Feed Mode |
G94 | Feed per Minute Mode |
G95 | Feed per Revolution Mode |
G96 | Constant Surface Speed |
G97 | RPM Mode |
G98 | Initial Level Return in Canned Cycles |
G99 | R-Point Level Return in Canned Cycles |